Most people think about their back in terms of the big lift, like the box on the dock or the bag dropped off a truck bed. Shifts are rarely built that way. Over eight or ten hours, the load your back handles is spread across many smaller moves: a tote pulled toward your belly, a tray lifted above shoulder height, a bin swung onto a cart, or a bag hung off one forearm while you walk. Each one is short. Together they add up, and they rarely appear in a job description.
This piece is for anyone who wants to describe their work with more detail before a visit. It is educational, not a diagnosis, and it will not tell you what is wrong with your back. It gives you a way to notice patterns so your description is specific and easy to follow.
Sort the loads by reach
Start with a plain list of where your hands go. On a normal shift, mark three zones: low, between knee and hip; middle, between hip and chest; and high, above your shoulders. Note which zone each item comes from and where it goes. A load that starts low and ends high is different from one that stays at belt height, even if the weight is the same. Distance matters too. An item held at arm's length pulls on your body differently than one held close.
Write down rough weights only if you actually know them. Case labels, crate markings, and the scale at your dock are good sources. If you are guessing, say so in the note. A guess marked as a guess is more useful than a number that looks official but is not.
Count the carries
Carrying is its own category. Walking with a load changes how your trunk works, because you are moving and bracing at the same time. Note how far you carry items, whether you use one hand or two, and whether the load sits on one side. A bag over one shoulder, a bucket in one hand, or a tool belt that shifts to one side may matter as much as a single heavy lift.
Include stairs and ramps separately. Going up a flight with a load asks something different from walking a flat hallway. If your route includes a door you push open with your hip or shoulder, write that down as well. These small actions are easy to forget when you are describing your day from memory.
Log the repeats and the holds
Some tasks are not heavy but repeat. Scanning, stacking, or sorting can involve the same reach many times an hour. Estimate the repeats for the task that takes most of your time. A rough estimate is fine, as long as you label it as one and keep the log in your own words.
Holds belong on the list too. Reaching up to steady a panel while you fasten it, leaning over a bench to keep a part in place, or keeping your arms out in front of you while you work all count. A hold can feel minor in the moment and still be the part of the day you notice most at the end of a shift.
Turn the log into a short description
After a few shifts, read your notes back and pick the three most common movements. Write one sentence for each: what you lift, where it comes from, how far you carry it, and how often you do it. Keep the language flat and concrete. A sentence that names the starting height, the destination height, and the rough frequency tells a clinician far more than a phrase like heavy lifting at work.
Bring the log and your sentences to your visit. Mention anything that changed across the week, such as a busier day, a new route, or a coworker who is out. You do not need a polished record. A rough, dated log written as the day happens is more useful than a tidy summary written after the fact.
When to stop logging and get seen
A work log is a tool for description, not a substitute for care. If you notice numbness, weakness, trouble controlling your bladder or bowels, or pain that spreads and does not ease, do not wait to finish a log. Seek medical care promptly. Emergency symptoms need emergency care right away.